Upload

Loading...

3D Printing Time Lapse Photography - Yoda

1,092,904

Loading...

Loading...

Loading...

Rating is available when the video has been rented.
This feature is not available right now. Please try again later.
Published on Jun 15, 2012

Time lapse photography of a 3D print on a Makerbot Replicator. This is my first print at .1mm layer height. There is a significant increase in detail compared to printing the same model at .2mm height. It takes longer, but in a print like this it is worth it. The layer ridges are still visible, but are much less evident.

.2mm is fine for general printing, including things such as brackets, toys, and iPhone docks. When you have a model with fine detail, give .1mm a try I think you will like it!

The 3D model can be found here: http://www.thingiverse.com/thing:14104

If you are interested in 3D printing, please subscribe to this channel for a series of demonstrations and how-to videos. If you have a question, I will reply in the comments below. Thanks!

Loading...

Advertisement
When autoplay is enabled, a suggested video will automatically play next.

Up Next


to add this to Watch Later

Add to