 Hey everyone, Drew with GeoArm and I'm back to talk to you about the Geo Alarm, GeoCP control panel and how to set up the arming or disarming requirement for the code. So if you get tired of having to enter your code every time and you don't want to have to do that because you use the app, what you can do is you can jump into programming by entering the hamburger icon, putting in your master code, then you're going to go to arming. So if in ARM stay, you don't really care if the code is used or not, you can already see that for arming, there is no code requirement. Now if you do want it to be required, all you have to do is just turn that on, then any time the system is armed, the code will be required. Disarming, this is always going to be on because disarming usually is going to require the code. If you don't want to do that, that's fine. You just go ahead and hit that button there and it'll change that to off. So now you can arm the system and disarm the system without the code. I don't recommend that, but it's an option. I'm going to go ahead and re-enable disarmed, but that is how you do it for staying. Go ahead and hit the back arrow and then we'll do it for leaving, okay? Leaving, same thing. You see ARM here, pass code, okay? And there is no option for disarm on this. It's going to require it no matter what. So that's more of an ARM stay feature that appears here, but you can toggle arming in whether you want that code to be entered or not at that time. So I'll go ahead and disable that. But that is how you set that up in the Geo Alarm, GeoCP control panel, whether or not you want your code to be required. If you have any questions or any comments, please leave them below. Other than that, take care, stay safe. Please like and subscribe to our page for helpful programming and installation videos.