 All right guys, so you have nine seconds to do it, right? You only have nine seconds to put your mask back on. All right, so whenever you put your mask back into your carrier, make sure your mask is sitting the way that you want it to, so that you open the mask carrier with your left hand, grab the mask with your right, close your mask carrier at the same time, and place your mask on your face. Remember, your eyes are closed and you stop breathing at this point. Okay, let's draw. Remember, sound alarm, close your eyes, stop breathing, pull up, open your mask carrier, pull out your mask, put it into your face, close the mask carrier. Make sure you're clear and sealed. Make sure that you hear a strap, give visual and sound signal. Nine seconds, nine seconds, all that. You guys ready? A little. And proceed to grab the M291 out of your pockets, please. Head and begin deconing your skin. Remember, the steps are to first decon your hand and then proceed to deconing your face outside of the mask, and the edges there are touching your skin, the mask is touching your skin, and then afterwards, proceed to decon your inside. So hands, put it to the other hand, decon the other hand, and after that you decon your face and mask. So all you try to decon when you go to your face, you try to decon where the mask meets the skin of your face. That way, when you break the seal, you don't contaminate your face when you try to... Nope, that's a stop. Yeah, try to... So you're not breaking the seal, yeah. I guess that's fine. I wasn't able to. Or you meet the skin with the mask. And remember, you're rubbed and away, rubbed and away. You wasn't able to see the sample from another person. Yeah, but you closed. All right. So in your face, you seal your mask again. So, put your mask back on, tighten the straps, blow out any air that's inside the mask, and seal your mask again by covering the side, the filter, and suck in air to make sure that it's suctioned to your face. Yeah, come down with me. Thank you, then. Thank you. It's good.