 Hi everyone. In this video we're going to be going through how we add switch addresses to our turnouts and also the sensors as well. So what this will do is when we click on the turnout here on our main line track which is a right hand turnout running into our passing side in this will activate by the Digitrax SE8C's the slow or tortoise slow motion switch machines that I have hooked up to the layout. So what we'll do now is we'll go in and we'll add those switch addresses for the turnouts and also the sensors as well. But to begin we do a right click on the turnout itself, go down to edit which opens up our edit turnout window, expand that a little bit more. Then what we need to do is click on turnout and we can manually enter or scroll down the turnet that we want to place. Then what we need to do is add our sensor as well so we can do this in the one window so we can add the turn out switch address for the turnet and also the sensor for that particular block as well. So we click create edit which brings up our edit block screen and again clicking back on sensor, clicking down the drop-down box and making sure that other three are selected. Click apply, click okay and then click done and then what'll happen now is you'll see that in this turn out here it's just disappeared that's because the state of the turn out's unknown. So if we click on it again you'll notice that the solid line that was running through here is now changed back to the way it was and if we click on the turnout itself it actually routes from the main line through to the passing solid line. So now we know that we have this turn out hooked up to the switch address which is LT89 and whenever that is clicked by the dispatcher on panel pro or by the push button switch on our fascia panels on the layout that this turn out will now activate. So what we need to do now is just add the sensor icon above that so again we go up to the top of the screen the sensor icon click there select ls3 from the drop-down box holding the shift key to a left click over the top of the turnout and then we can add that sensor so at this time it's in an unknown state you can see what a text label that comes up it's ls3 and if we click that that turnout is now occupied and if we click it across like that you can see that it's on a diverging route through to the passing solid but still occupied and we can manually turn that off and that's it for this video.