 This is Alex again. In my previous or in the post to lock video I was talking about my custom handmade home brew follower and how I liked it for re-pinning and I'm going to see if without completely blocking the shot if I can show you why. So when you get the pin in there and on the deeper one sometimes it will just drop and kind of cock that a little bit, lock the, oops, so you see it keeps the pin from going flying out the rear if it were hollow but you can kind of, I don't know how long that's showing up we'll see, you can kind of, it kind of keeps it there then you can just sort of rotate and get it in there and I just find that gives me just a little bit extra control when I'm doing this and if I need a an end with a without the milling then I just flip it around so I only did one end I just used a little mill file to do that took about five minutes so you could use a dremel too if you're not into filing we'll do a video on filing it at some point anyway doesn't keep you from dropping the pin just a little tip so thanks