Upload

Loading...

This is simplest possible board for ARM (STM32) - single layer, single sided, and only 1 capacitor

36,086

Loading...

Loading...

Loading...

Rating is available when the video has been rented.
This feature is not available right now. Please try again later.
Uploaded on Jun 30, 2011

Many people think that ARM is very hard to use and require 4-6 layer PCB with lots of support circuitry. This proves that you can have it working as simple as plain old AVR - just single layer single sided board, linear regulator (3.3v), capacitors before(optional) and after(2.2-4.7uF ceramic) regulator and single resistor at BOOT0 pin to enable boot from internal flash. That's it, your ARM is working :-) Also, this PCB is homebrew using toner transfer method, no rocket science. Microcontroller is simplest STM32's stm32f100c4t6b - just under 1$.

Loading...

When autoplay is enabled, a suggested video will automatically play next.

Up Next


to add this to Watch Later

Add to

Loading playlists...