 Hello, my name is Damien. I'm NFC application engineer, ST Microelectronics. And I will show you today how to program ST25 dynamic tags with RFID reader and antenna. So to do such, we have a reader from our partners, FagElectronic. We have the model LR1002 that is connected on one end through USB cable to a laptop running the PC software that's going to control the reader. On the other end, we have the 30 by 30 centimeter antenna also from FagElectronic that generates a field where we have put ST25DV discovery boards that simulate real-life products ready to be shipped from your warehouse. So I take one of those boards and I power it up. It simulates a real-life product embedded ST25DV dynamic tag. And let's assume that on the production line, we program the board for the Italian market. But I just received a call and an order for Germany, so I need to change the language parameter. I will take this board, put it back in front of the field, in the field in front of the antenna. And with the PC software, I will run an inventory. Here we see we detect 10 NFC forum type 5 products that match ST25DV tags on the board. And I will broadcast a command to all tags, command that writes data in a particular EPROM's location, then indicate that these products are meant for the German market. We're going to check that it's programmed right. So at boot up, the STM32 microcontroller from the board is going to read data from the E-square prompt on the tag. And based on the information that it reads, it will select the proper language. So here are the boards in the field over there have been programmed with a single command in the non-address mode of 15-693 ISO standards. So to wrap it up, we have seen that with RFID technology, you can program boards that are already in your warehouse, packed, and ready to be shipped. You don't need to take them out of the boxes. You don't need to connect to them with a plug or with a cable. You can change the parameter settings remotely with the RFID industrial reader and antenna.