Loading...

DIY Synergy horn test

65,188 views

Loading...

Loading...

Transcript

The interactive transcript could not be loaded.

Loading...

Rating is available when the video has been rented.
This feature is not available right now. Please try again later.
Published on Apr 13, 2012

Testing out my Buget DIY Synergy horn in the backyard, Intro from Rango.
I am about 50 yards away before I start walking up to it.

Build thread can be seen here:
http://www.avsforum.com/avs-vb/showth...

The two DIY folded horn subs below it use a 8" Dayton DVC driver, and are powered by a Dayton APA-150.
The synergy horn is powered by a Yamaha HTR-5450. It was crossed over at 90hz to the DIY horn subs, I did not have the crossover on the subs set up right so there was a large dip between 70-100hz.

The DIY synergy horn uses four 5.25" sony neodymium buyout woofers, and a 1" dome buyout tweeter, crossed over at 1100hz.
Cost:
Drivers: $6.76
Crossover parts $18.54
MDF and other materials ~$15-20
Total: $45

Camera is Cannon HF10 with built in mic, wind was about 10 mph, there was also some noise from a jet flying overhead in the background. Overall the camera's built in mic did not do it justice, I"ll have to try again with some other mics.

Loading...

When autoplay is enabled, a suggested video will automatically play next.

Up next


to add this to Watch Later

Add to

Loading playlists...