 So the other day I did a video about an ESP32 cam board that I got that the programmer board that it came with The USB port wasn't soldered on it was just clipped in place. Well, I ordered a Replacement part haven't sent back the original yet. That's what that was. I have not opened the replacement yet But after doing the video I actually went back to the listing on Amazon looked at some of the poor comments the one-star comments And there were at least two or three other people who had the same exact problem USB port popped right off So let's see Again, have it open to get you're gonna see with me. Does this replacement board have the same issue? Okay moment of truth here Let's see No, there's no quick tag. Where's my scissors here we go Okay Well, this one has the camera attached last one I had to attach the camera. Let's see Zoom in here Focus Doesn't look like there's much solder on there Let's try plugging in a USB port and see if it pops off when I say plugging in a USB port I've been plugging in to the USB port. Let's do it Well, it didn't pop off like the last one did It doesn't look like there's any solder on there, but it's holding so I guess I'll keep it well Again, I'm planning on turning this into a dash cam for my car Where I can wirelessly access it when I pull my driveway and pull the videos with ease and In that case, I'll do a video hopefully on that. So keep an eye out for that. Be sure to subscribe like share comment I thank you for joining me and Yeah, I hope this USB port stays on. I mean if it does pop off I'll probably just solder it back on instead of ordering another one because it's a good price and the board works well And hopefully I'm gonna be unplugging and plugging it in much I'll just be plugging in after programming it and leaving it So thanks for watching. Thanks for this watching this follow-up video And I hope you enjoy my videos and be sure to like share subscribe comment all that good stuff. Have a great day