 Welcome to the Argos assembly guide for BMX bikes equipped with the gyro braking system. This video guides you through the basic steps in assembling your Argos cycle. For this cycle we recommend allowing 60 minutes for completion. This cycle has been rated a level 3 difficulty. Some help may be required. There may be some slight variations between the cycle assembled here and the cycle you have. This is OK as the procedure is the same. Remember to stay safe and legal with lights, cycle helmet, lock and many more accessories available at Argos now. Unboxing the cycle. Remove the seat and accessories from the box. Take extra care when lifting. When ready, remove the cycle from the box. Help may be required. Start removing the protective packaging. Use scissors to cut the cable ties where necessary. Open the kit box or bag containing the pedals, tools and all the accessories required to assemble the cycle. Attaching the handlebars. When attaching the handlebars, first loosen the four handbar clamp bolts and remove the clamp. Insert the handlebars. Reattach the clamp to secure the handlebar in place. Using the Allen key provided, tighten the bolts alternately until the handlebar is secure. This cycle is fitted with a gyro braking system. You may notice the gyro braking system has excessive play. This is perfectly normal. Attaching the rear reflector. Some rear reflectors come fitted already. If yours does not, you will have to attach it before fitting the saddle in place. Slide the reflector onto the saddle post and tighten the screw to secure it in place. Inserting the saddle. Align the saddle post with the bike frame. Remember to pay close attention to the minimum and maximum height marks. Insert the saddle post to the desired height. Tighten the seat clamp bolt with the Allen key provided to hold the saddle in place. Attaching the wheel. Located on the front forks, unclip the guide pipe noodle from the v-brake assembly. Fitting the front wheel is easier with the cycle upside down. Some assistance may be required. Firstly, remove the axle protector caps by pulling them off, not turning them. This will prevent the wheel nut from getting stuck in the cap. When ready, insert the wheel so the axle is located at the base of the forks. Now that the wheel is in place, move the retention washer to the base of the forks and tighten the outer wheel nut with the spanner provided. To finish attaching the wheel, reattach the guide pipe noodle and rotate the bike upright. Attaching the pedals. Firstly, unwrap the pedals. Note the left and right markings. The right hand pedal always attaches to the side with the chain. Screw the right pedal clockwise and tighten with the spanner. When fitting the left hand pedal, remember to screw anti-clockwise. Attaching the bell and front reflector. The bell and front reflector may also need attaching to the cycle. Starting with the front reflector, loosen the screw and attach to the handlebars. Once attached, tighten the screw to keep the reflector in place. Follow this same procedure for attaching the bell, but place on the left near the hand grip for comfortable operation. Inflating the tyres. Use a pump to inflate the tyres. Check the tyres are inflated to the correct pressure. The recommended pressure will be located on the wall of the tyre, attaching the stunt pegs. The stunt pegs are attached by screwing them onto the wheel axles in a clockwise direction. Tighten them by using a screwdriver to turn the pegs. Pre-ride checks. Before riding your new cycle for the first time, let's do some pre-ride checks. Check the saddle is secure by twisting it left and right. Spin the wheel to make sure there's no side-to-side movement. Make sure there's no excess play in the wheel hubs by moving the wheel left to right. Check the pedals are fully secure using the spanner provided. Check the brakes are operating correctly. Make sure the handlebars are tight and are turning with the wheel. Assembly complete. Congratulations! You now know the correct procedure to assemble your new cycle. Remember to take extra care on your first ride.