 Okay guys today, we're going to be changing this carburetor on this scooter Stay tuned. I'll show you how to do it. Okay guys as you can see I've already got the seat out It's sitting over there, and it's just held on by There's a nut that goes on this stud nut there. There's one down here And one right there and that pulls that pulls that whole assembly up out Okay, it's the cargo bay and seat So what I'm gonna do you don't have to take this off, but I'm gonna take this off I'm gonna take this off to show you just for Video purposes So what we're gonna do right now? See there a little bit there There's two screws here and Then it just you know those clips and just pops right out. It's gonna set them aside right there That'll be my little work bench and That's all there is to that Okay guys what we're looking at here That's y'all stand And there's the carburetor right there, but there's the carburetor now What you can do There's a screw right here. You loosen that it's a clamp and That'll pull your box off your air breather box, which comes clear out here to the side to get air and you can take this loose and Loosen that one and kind of wiggle it and bring it out You gotta be careful there's some cracks in this, but it's not in the part where it's sucking air and Then of course you have to unhook the throttle cable But I'll show you how to do that in a minute And we have to unplug the choke This is an automatic electric choke Just follow it around And there's the plug for can you see that because I can't see the screen Just fish that over here out of the way Just for now Okay Now what I've done. I've already you can take take this choke out There's a screw over here on this side and a little screw on this side And there's a little keeper there and I'm just going to go ahead and take it out Because the carburetor that I have got All that with it now right here guys There's that little clip That holds the choke in Just goes around it Screw here and a screw there Okay This carburetor this it does run, but it doesn't run right Slacking power it's got a Kind of a funky idol to it so Now you're going to want to Unhook the fuel line And it comes right down here Maybe I can get you guys Right here's the fuel line now some sometimes these have a little clamp It'll look similar to this this one apparently does not have one So just pull it off there Now you will get a little bit of leak leakage, but it's not going to run out And I'm just going to clip it up. I'm just going to put you put this line right here on this stud Just like that so I won't do now like I said it's not going to come pouring out because The battery like blinking it's not going to come pouring out because this has a fuel pump on it And the fuel pumps right here on the side Okay, so Let's keep going on with this So I'm going to loosen this clamp up For the breather box and it just pulls up right off just like that and it'll turn up out of your way You can actually take it clear off, but I'm just going to move it up here out of the way And we're going to do the same thing with this one. I know what you're thinking The throttle's still hooked up. Yeah, it is, but I'm not worried about that at this second Now loosen this up until it moves freely And you should be able to wiggle that right off of there Now right here I don't know if you guys can see that That's where your throttle cable comes around to So what you're going to want to do Let's put that on full throttle like that pull this Your cable out a little bit and it slides right up out of that There's a little closer look Now this has A drain on it That's to drain like after a while, you know every every so often pull this this little plug out goes down Underneath down here by the breather box by your Kickstarter And that's that's all there is to that Now it's going to be easier for me to loosen this bolt Or not, okay, so yeah, this goes down by the breather box You'll see it. There's supposed to be a screw in it. Apparently it's missing one But I'll put one in it. I want to get the new carburetor. Which does come with that I'm sure what size that is I'll let you know in here in just a second 12 millimeter Okay And I just dropped my tent. Okay, so what we're going to do here guys Right here See, this is an adjustment. You really don't want to fiddle with that unless you have to so What you're going to do is only loosen one of these Which is going to be Let me move this back. It's going to be this one. Okay This is the one you're going to take off and you can pull it back and I'll show you right now The other one is a jam nut that holds it into place there So what you're going to want to do is take this nut off That or like still blinking Just a second ago. It said 33 minutes Okay, now that's going to hold it on there. It can't come off. You won't lose it now. You just slide this back like that And then slide that up through that slot and your carburetor is off That's all there is to that Now this one is a I believe a 19 millimeter right here On the inside diameter I think it's 19 millimeter you check all all these online And you can get these cheap So There's that now. I'll show you how to put this all back together here in just a minute And I'm going to change the battery too. So hang tight guys. I'll be right back Okay guys We're back have the new carburetor right here You see it all brand new I've checked it on the bench alongside the other one to make sure everything was the same It's all the same So we're good to go To put on our new carburetor that other way Let's slide it on here like that I showed you guys how to get the Throttle cable off It goes back on just backwards of how you took it off Just slides in there. There you go this All right get a little concerned there for a minute. Look the same. I was like, oh no, okay Now Don't screw that on And remember we didn't mess with that. So let's turn the throttle and see If it's opening all the way Yes It's returning. Yes Okay, we're good there Now we'll put our dust boot back over that And We will tighten this down And it don't have to be super duper tight Just snug it up Make sure your carburetor is all the way up in To the intake boot. There it is. You'll feel it like pop. I got tight deal this up here and Tighten this boot down and it should be Even because it's got a tab there that kind of goes into them two little rubber ears there And tighten this up Until it's tight it'll stop So you don't have to worry about over tightening it or under tightening it Just go until it stops. It'll stop on its own there you go Now let's put our Air cleaner or air brooder box hook it back up I may have to get in your way for a minute But it goes on the same way. There you go. It just pushes on now if it doesn't take this Take this rubber piece off right here Heat you some water up on the stove Just dip the end that you're having trouble with Dip in the water for about two seconds bring it out and it'll go right on every time I know this because this wasn't hooked up when I got the bite And I couldn't get it on there. So that's what I had to do won't hurt a thing guys So just make sure that you're real careful with that stuff And you'll be fine There's that Now we're going to run our choke Underneath that way it's out of the way of anything And we're going to plug it in over here make sure the greens green yellows to yellow plug it in now Now we're going to hook up our fuel line Which I need to get I need to pick me up some fuel line because this one looks kind of cracked up here a little bit kind of dry cracking It's still limber, but I don't like the cracks on on a On a fuel line. So let's get it hooked up See it's kind of Kind of cracked up there. So let's fix that real quick at the end of it all So yeah, I'll probably run a new fuel line on it this weekend And put it Right back where you took it off. There's only one place that'll go Make sure it's all the way up on and it is And I'm going to get new fuel for I did clean that filter But uh, yeah, it's all I did clean the filter. It's fine. Any time you put a new carburetor on it's always good to clean the filter All right, this does have a It does have a fuel pump And it does have an accelerator pump. So let's crank it over a couple times Let it get some fuel into the carburetor Now pump it a couple times up here with your throttle Let's try it. Okay What's going on? It may take it a minute to pump it up or never didn't find out what that's for Okay Make sure this is on There we go. It just took it a second Now here's your idle mix your screw your idle right there You shouldn't have to mess with it, but When it's warm if you have to You got to turn it down just use the full screwdriver right now I'm going to let it warm up and see what it does, but don't ever adjust that one. It's cold. There you go Guys don't want to see that ugly mug Damn. All right guys I have to shut this off So hopefully the sound came out the same way with putting the seat and You know that front cover just reverse order. It's real simple. These things are real simple Of course check for leaks. I'm going to do that. I'm going to let it run Let it get warmed up. So if the idle needs adjusted it sounds pretty good right now Sounds like it's a little more peppy like it should be so That being said guys, so there's how you put a carburetor on this thing I still got to get a video up when I put the electronics in Bear with me. But anyway, here's one for you carburetor, this is a 2013 I do believe Uh, it's a propel. It's one of those Japanese little scooters. You can buy them brand new I think it's a 50 cc. You can buy them brand new for like, uh, I don't know 15 1600 bucks depending on where you go to get them. That's online. You can buy them for that It'll run me about 45 So, you know, it's just a good little scooter to ride around on but I don't know if I want to resell it or keep it. She's kind of wanting to keep it But you know, I kind of bought it to resell but I got it at a damn good price I've got less than 200 dollars in this thing guys. So Uh, But I'm gonna clean it up and everything and uh get it running and Take the first bend see how it goes. So listen guys. Thanks for watching. Stay tuned for more videos At a comment somebody wants me to start vlogging. I'm gonna see what I can do about that with work and everything like that I may vlog while I'm at work. So we'll see how that goes. If not, I'll Do some vlogging in between times, but uh, so it may not be a daily vlog But I will do some Vlogging for you guys. I will do a vlog this weekend and see how it goes. How's that sound? Anyway, again, thanks guys So much for watching, uh, my channel and monkey's channel. We appreciate it monkey 1000 check her out Give her like give her thumbs up subscribe. She'll subscribe back. I will do the same thing Uh, if you subscribe to me, you haven't heard from me in a few days Get ahold of me again and and remind me look I subscribe I will subscribe back. So, you know, we're all in this together guys. Let's have fun. Let's enjoy things. All right, guys Got to go me and bruno. We're out. Remember she bear the myth man legend. I'm going. Bye. Bye now