 Hey everyone, Drew with GeoArm and I am back to talk to you about the Alula Bat Connect and getting it connected to the Honeywell Vista panel. I already do have a video that shows the Bat Connect getting connected with only four wires to the Vista. I've actually found that that doesn't always work, so that is a method of doing it according to the manual. This is going to be adding tip and ring into that mix as well, so there's going to be a total of six connections here. So what we want to do first is we just want to go ahead and get the Bat Connect open and it's a little tab right here on the side. Just press that down. Once inside you'll notice that I've already pre-wired this. This does not come with wires or pre-wired at all. You have to get yourself a strip of between 18 and 22 gauge for conductor and 18 and 22 gauge to conductor. Or you can just you know snip off the other two connections to use here. So what I've done is I've wired in red to ring and black to tip. This is my phone cable connection. It's going to wire into tip and ring of the panel. And now I also have GN, which is a green wire. YN, which is a white wire because mine doesn't have a yellow in there. So green to GN, white to YN, black to GND and red to 12V. This is the connections that you're going to make inside of the actual Bat Connect itself. Now we'll go ahead and we'll get it wired to the panel. So you probably want to pull the wire in through the back or do something like that, but I'm not going to do that. I'm just for time purposes here. Now we're going to be wiring it to terminal 4, 5, 6 and 7. So 4 is going to be a black wire. It's going to be the ground. So we'll get that in there. There will be other wires in these terminals. Let's go ahead and put this in there along with it. Now we'll go red wire to number 5 and then we're going to go my white wire, or it could be yellow for you to number 7. Skip 6 there, but that's where the green wire is going to go. So white or yellow to 7 and then green to 6. And once you get these wired in there and tighten down, then you should be ready to get your tip and ring wired in. And now tip and ring is going to be all the way to the very far right of the wiring strip. So we're going to be moving down here now after we've got these connections in there. So we're going to be going into terminals 23 and 24 here, these two. If there's any wires going into 21, 22, 23 or 24, go ahead and take them out because they don't need to be there anymore. At this point, this is all that's going to be used for communication. So we'll go ahead and we'll grab our tip and ring wire. So we're going to go the black wire to terminal 23 or tip. And once you get that tightened down, then you're going to go ahead and take the red wire and that is going to go to 24 or ring. Go ahead and get that tightened down in place after you've tightened that down. This thing is ready to be powered. I'd recommend going ahead and getting your internet connected now. Get this out of the way here. I'll get my internet connected right into this slot here. So let's get this wire down. All right. So now at this point it is ready for activation and power. So go ahead and take down your Mac and your Mac CRC and then give us a call so that we can provide you some low cost monitoring for this device. Ladies and gentlemen, this is how you wire in the Alula Bat Connect to a Honeywell Vista 20p using the tip and ring. Take care. Have a great day. Thanks for watching this video where you can view valuable links pertaining to this product, similar how-to videos, and our low cost, no-contract alarm monitoring services.