 So today we're going to rebuild the transmission if you watched part one of my transmission rebuild I took this apart and This is off a 98 scrambler. I thought this bearing was bad. It turns out. It's actually really good First thing to do when assembling is we're gonna put this Then the clip we took out already put back in This brace goes Get back in four screws, I'm gonna put some lactite on here take a longer to put back together Terms right put a little grease in there already. That's the gear your drive drive shaft That's going to go Line up in a hole like in there, and then we'll put these all in I'm just snugging these up. I'll talk them later Move For the fun part Line up that shift work You got a cameraman today the shift work with this dog gear It's gonna go on there as I'm putting this all back together Together and I notice my chain is binding up see that right there. It's not turning like it should So I'm going to put a different chain on that was probably part of the issue Had happened to have a used chain laying her on so I put the chain on I test the operation make sure it works Your shift work. It's all good. The next step is to put the Gear and this drive back together all at once I'm gonna put that on and that on all at the same time now the last step would be just put that clip in There's a little handy-dandy tool here. This is the one I usually lose And that clip goes right in here a little bit to get that Ring expander on there. The last step would be to do is to Lock everything up. We're gonna cock. Use that gasket sealer I got right here And seal up everything put your cover back on put your bolts on and you are done That completes our video for a 1998 Polaris scrambler transmission Thanks for watching and subscribe to my videos or my channel I have lots of other videos on there and I got my cameraman today. My son's around the camera. So I appreciate it till next time