 Hey guys, it's Kevin. Today, I want to look at this printhead problem with HP 8000 series. It usually happens when you change to a brand new printhead. If this is the case, you'll probably damage the F5C cable during the installation. For example, like this one, half the cable gets snapped off. Today, we got another printer has this problem. OK, let's take the printer part and take a look. You need a T10 screwdriver bit. If you don't have it, I'm going to put a link above. That's a must have if you have HP. Remove 8 screws from the top. Count it. Make sure it's 8. And this printer hinge can be removed by simply pushing forward. Now the scanner can be put up to 90 degrees. And expose some screws underneath. Now there are four screws to be removed. Now the panel can be peeled off from both sides. But let me show you this for the hinges. So pay attention to where the hinges are. So next time when you install, you need to install this way. You don't have to uninstall this. But I know 99% of the chance is going to fall out. And the whole top cover can be removed. Now you can have something has a hook. And to remove those two springs that's holding the brinette. And remove the cartridge. And now the cable can be removed. And now we can take a look. And you'll see the problem. For replacement cable, you can go to bchtechnologies.com and just type in FFC in the search bar. You're going to see what you need is a two-piece 15-pin for HP Offset Pro 8000 series. And this kit comes with two cables. Do not remove the old cable completely right now. The old cable will help you to decide how to wire the new cable. You're going to see a red bar on one of the cable and two bars on the other cable. The cable with one bar is to your left. And the one with two bars should be installed on the right side. Wire it through the middle. And here, on this end, it's the same thing. One bar should be on your left and two bars on your right. And check your old cable before doing the next step. OK, next step, we're going to remove this clip. You can see we have left this end of the clip a little bit. Let me jump to the right. Here's on the right. And here's the end of the clip that I can lift a little bit. With my left hand, the lifting dot end. And then I'm going to poke through this hole on the top. And one more on the bottom. And do you think this clip is going to lose? And now we can remove that iron core and the old cable. And then we can put a new cable in. This time, we'll put a cable in. Make sure you use even force. And it's helpful if you hold your left hand steady and use your right hand inserted instead of moving two hands. Make sure your printhead is safe and securely and flat. And the final check on the timing belt. Make sure it goes through the reader. This one will show a scanner error because I detached the scanner so there's no scanner. And I bypassed that and everything looks fine. I hope this video will solve your problem. Sorry I didn't post too much video recently because I'll be really busy vacationing. There's something called a time-share. A time-share is such a scam and don't buy it. However, I'm fascinated by the time-share. So I read a book and I spent about a year and a half and studied the time-share system. Now I can beat a scam. I'm thinking making a new YouTube channel talking about how to beat a time-share scam. Leave a comment if you think it's a good idea. So have four more vacations to go this month and the next. Happy printing. Cheers.