Loading...

How To Make McKenna's Loft Bed

192,152 views

Loading...

Loading...

Transcript

The interactive transcript could not be loaded.

Loading...

Loading...

Rating is available when the video has been rented.
This feature is not available right now. Please try again later.
Published on Apr 15, 2012

This is a loft bed I made for my granddaughter Taylor.

Since the video I added lighting to the bed. On the underside of the bed above the desk I mounted a battery operated LED light that I bought at the hardware store for $12. Being LED it will not get hot and it turns on with the touch of a finger. I am trying to figure out how to post pix of the lighting with the video.


I bought the little dresser at Hobby Lobby and the LED light at Lowes.
Okay here are the measurements for the loft bed.
The 5 legs are 1"x1"x24"
The bed board is 11"x24" and made from 1/4" plywood
The two walls are 10 1/2"x21"
Shelves on the one wall are 1/4"x2 1/2"x 9 1/2"
The desk on the two right angle sides is 11 1/2"x10" and sits about mid way between top of bed and floor. The other side I just free hand a curve.
The chair legs are 1x1x7, seat is 1/4 plywood 7" across the front tapering to 6" across the back and 7" deep, the back is 4" high and 4 3/4 wide.

To make the bed you will need 5 1x1x36, 2'x4' 1/4" plywood, about 10' of decorative trim.
Paint I used Krylon white, gum drop & rich plum.

Loading...

When autoplay is enabled, a suggested video will automatically play next.

Up next


to add this to Watch Later

Add to

Loading playlists...