 So I bought myself this here a little lathe a while ago and I got it used and really cheap and right from the beginning it had a problem with the pulley that was on the motor that runs this belt and then that was a little bit hard on it and I'm sure I wore it worse than it was so you see at the edge here it has these little teeth kind of those are supposed to go all the way across and they grip into the belt and make everything turn and without those little teeth this spins around and the belt doesn't really move as so I guess I need to throw the whole thing out right no since this is worn down so much it leaves enough space to put little sticks across I'm thinking some copper wire they can drill a hole on that end and then the part that goes on this side of the pulley which is the same as this thing screws on here and I'll just drill a hole right through the whole thing and put a bunch of little copper sticks through now I'm thinking to make sure they're lined up perfectly I can rest the drill bit right between the teeth which wouldn't normally be ideal but since the teeth are completely gone these teeth at the end are useless I'll just use them for lining stuff up now let's find some right thickness copper wire good thing I have a lot of wire I found some single strand wire here I don't know it's like 12 gauge or something yeah that looks about right all right let's go surgery mode it's easier if I had a desk but I don't oh I can't wait to have a bigger workshop with a desk I'd fit good stuff yeah this part goes on knots why do you think yeah or bolts it goes on that's a little it's a little tiny those are little nuts and bolts looks way cooler than it did before sweet all right I got that on there with the belt around it originally you could put this on there take off half the pulley put the belt on but I don't want to take it apart then I'll have to get all these back in their holes so I'm just gonna put it on I'm gonna need both hands for this all right let's check this out oh way better than when it was new not that I had it when it was new all right back to what I was doing