How to Create a Phenakistoscope





The interactive transcript could not be loaded.


Rating is available when the video has been rented.
This feature is not available right now. Please try again later.
Published on Jul 15, 2010

Watch more Animation Techniques videos: http://www.howcast.com/videos/148840-...

The phenakistoscope is a predecessor of the flip book, but don't worry: it's easier to make than pronounce.

Step 1: Sketch a plan of your animation
Plan out your animation with sketches. There should be 8 to 12 steps, each representing a frame.

The best animations for a phenakistoscope are cyclical, like a horse galloping or a child jumping rope.

Step 2: Draw a circle
Anchor your compass point in the center of the stiff paper and draw a circle that just touches the edges. Leave a small mark where the compass is anchored.

If you’re using a manila folder, cut it along the crease and use half of it as the stiff paper.

Step 3: Bisect the circle
Use the ruler to draw a faint line that bisects the circle.

Step 4: Divide the circle into pieces
Use the protractor to divide the circle into equally-sized 'wedges,' with each wedge representing a frame in your animation.

To divide the circle into eight wedges, each piece should be 45 degrees. For 9 wedges, 40 degrees; 10 wedges, 36 degrees; 11 wedges, 33 degrees; and 12 wedges, 30 degrees.

Step 5: Cut out the circle
Cut out the whole circle.

Step 6: Cut slots
Cut small rectangular slots about 1/8th inch wide by 1 inch long along the separating lines of each wedge. Start at the very outside of the circle and cut inward.

Step 7: Make a small hole
Poke a small hole through the center of the wheel, or slightly widen the one that is already there.

Step 8: Repeat on drawing paper
Repeat Steps 2 through 5 on the drawing paper, but make this circle 2 inches smaller in diameter.

Step 9: Draw your animation
On the drawing paper circle, create your animation step-by-step, clockwise around the circle. This is your animation wheel.

Step 10: Align and cement the animation wheel
With a small dabs of rubber cement on the back, align the animation wheel so that it is centered on the thick paper wheel. Allow 10 minutes for the rubber cement to dry.

The smaller wheel should come about to the slots you cut in Step 7.

Step 11: Poke the thumbtack
Poke the thumbtack through the animation wheel and the hole you created in the heavy paper…

Step 12: Push the thumbtack into the eraser
Push the thumbtack into the side of the pencil eraser. It should be in firmly enough to stick, but still loose enough for you to be able to spin the wheel freely.

Step 13: Face the mirror
Face the mirror, then hold your phenakistoscope up with the animated side pointed away from you.

Step 14: Spin the phenakistoscope
Gently spin the phenakistoscope while looking through the slits. The animation will appear in the mirror.

Did You Know?
The phenakistoscope was invented in 1832 by the Belgian physicist Joseph Plateau.


When autoplay is enabled, a suggested video will automatically play next.

Up next

to add this to Watch Later

Add to

Loading playlists...