 Welcome to the SNAP. This is a segment where we answer frequently asked questions and provide helpful tips in a very rapid fire format. So let's get right into it. In today's episode of the SNAP, I'm going to be showing you some tips to get the most out of your M+. Some heating tips and general advice, so that way you can get the best tips possible. For these advanced heating tips with the M+, I recommend using the Honest Torch, which is a single torch with a pinpoint precision flame. It also has a clear fuel chamber and is easy to adjust the flame height. Now, part of using any DynaVap device is knowing how to control your heating temperatures. Let's start with the low temps and work our way up. And always remember, heat the tip for a tasty rip, heat the base to launch the space. For low temp heating, start by rotating your device and heat near the end of the cap by the letter D. This will help you get that flavorful, terpy hit that provides more heady effects. For higher temperatures, the key thing to remember is low and slow. Aim your flame on the V on the cap. This will result in longer heat up times, but provides you with a denser vapor and more potent extraction. It's great for those looking for a more couch lock body effect. 10 Minutes Later Next, I'll demonstrate a single heat cycle extraction, which is basically just clearing the bowl in one heat cycle. Now, while this is the most time consuming technique, it is also the most potent and rewarding for those looking for that kind of experience. Using the dimples on the M+, tip as a guide, aim the jet of your torch at the dimples and rotate. For clearing the tip in one go, it is important to keep your Dynavabs angle upright, as this helps provide an even extraction with less potential for hotspots of form. That's going to lead to combustion. Now, these tips are also applicable to the new titanium M's with some tweaks. As you can see in this split screen, a titanium tip heats up considerably faster than a stainless steel tip. Take note of this while you are heating your device and adjust your technique accordingly. If you find that the tip is heating up too fast, try backing the flame off a little bit further back or lower your flame height. Each Dynavab tip heats up differently and it may take some practice to get a better feel for the changes, but once you do get it right, you'll know it. You could just say everything clicks into place. Thank you for watching this episode of The Snap. I hope you now have a better understanding on how to get better performance from your M+, and you're getting those hits that you've been chasing after. If you found this video helpful, click the subscribe button and give us a like. If you like what you see, make sure that you check out the other videos on our YouTube channel.