 Hey everyone, Drew with GeoArm, and I am back to talk to you about the Qolsys IQ4 panel and the programming of the PowerG PG9914 wireless motion detector into the panel. Very easy to do here. We're gonna go ahead and get started by making sure that you have your materials ready here. Your motion and the battery are specifically what's gonna be needed. Go ahead and pull down from the top on the drop-down here, hit settings, then you're gonna go into advanced settings. It's gonna prompt you for your code. Mine is still factory, so I'm gonna use 2222. You're then gonna hit installation, then you want to hit devices, and then security sensors. Once you've hit security sensors, go ahead and hit auto learn sensor. At this point, it is looking for the actual device itself, even though we don't have the battery in it yet. That's okay. So what you're gonna do, these are kind of complicated to open up for some reason. I was having a little bit of a hard time earlier with it, but you just press down here, and then you just separate it. So it's a little tricky. It kind of feels like it might, you know, break at it, but it won't. So just press it down, and then just separate it like so. Okay, once you've done that, go ahead and get that cover over to the side. We're gonna get our battery inserted here, okay? Also, you'll see that there is a switch here. This switch is the switch that we're gonna use to enroll this device. So what we're gonna do is we're gonna pop the battery in. Okay, polarity does matter. Once that's in there, what we're gonna do is we're gonna press and hold down that little learn button in there, and then release it, and it should learn it in here, and there it goes. It learned in. So once we've got it learned in, you're gonna hit okay. At this point, it's gonna ask you for all the settings that you want to put in there. So the serial number, go ahead and confirm that that serial number is correct by locating the serial number on the device itself. Once you've confirmed that the serial number is correct, which I have, you're gonna go ahead and move on. It says sensor type motion. Yes, this is a motion. Then you're gonna set how you want the motion. An instant motion. If you want it to have a delay, you can do that as well. There's also several other settings that you can set in here. High traffic shutdown, the activation LED, if you want that thing to illuminate when you walk in front of it. The name you can adjust, it's called motion detector right now, but you can put in a custom description if you choose to. Also, there's a bunch of other preset names that are in there. So we're just gonna leave it as motion detector. Chime type. I don't want this thing to chime. I mean, it's a motion, so every time you walk in front of it, it chiming, probably get a little annoying for you. So I recommend leaving that off for motions. Voice prompts, I'm not gonna turn that on, and the source is power G. So once I've done this, this sensor is ready to rock. I'm gonna go ahead and hit add new, and it'll enroll the sensor into the actual panel itself. Once that's done, you'll hear it say sensor added successfully. It also says it down at the bottom here, and that's how you learn in the PG9914 power G motion detector into the brand new Qolsys IQ4 panel. If you guys have any questions or any comments, please leave them below. Other than that, you guys take care and have a great day. Make sure to subscribe to our YouTube page and click the show more tab underneath the video where you can view valuable links pertaining to this product, similar how-to videos, and our low-cost no-contract alarm monitoring services.