Upload

Loading...

Glider RC setup

3,051 views

Loading...

Loading...

Transcript

The interactive transcript could not be loaded.

Loading...

Loading...

Rating is available when the video has been rented.
This feature is not available right now. Please try again later.
Published on May 13, 2012

This is how I have my transmitter and receiver setup for my Easyglider.
I am using a Graupner HOTT MX-12 with a Graupner GR-12
Removing the motor from C1 was rather difficult and then also assigning it to a switch meant programming both the transmitter and receiver.
The motor at Channel 1 was assigned to channel 5 which was free as the GPS is plugged into channel 5. Then I reduced the controller side output of channel 1 to -0% +0% with a positive neutral setting, allowing me to move the channel 1 stick without effecting channel 1 directly. then the switch was assigned to turn channel 5 from -100% in the off position to +100% on the on position. The same switch was also assigned to my timer so that I can keep an eye on motor run time to keep my batteries from blowing up.

  • Category

  • License

    • Standard YouTube License

Loading...

When autoplay is enabled, a suggested video will automatically play next.

Up Next


to add this to Watch Later

Add to

Loading playlists...