 To insert these LEDs the best thing to do is to twist the copper wires together carefully, they're very brittle, so that the ends won't Snack on the lighthouse fittings on the on the cap here Once it's twisted together you can insert them into the hole Like that And then feed them through pick them up from the other side put the cap upside down So you can get a hold of the wires and carefully Pull the LED into this hole It's almost like threading a wire in a needle. These are very thin And you have to go slowly because it's very easy to Pull too far and have the LED drop out on the other side I normally stop around here, which is about five mil before I reach the light fitting And thread all my LEDs in in that in that way Once I'm done With that process I'm going to add the micro crystal clear in the in the lens openings And let that set up ever so slightly so it acts as a little bit of glue Before I pull the LEDs to the final place the micro crystal clear applied to the lens openings Looks rather messy right now, but don't worry once you pull the LEDs in and put them in position you can Wipe away the still wet excess micro crystal clear, and you won't see the difference It will just work