 Hello, and welcome to this STLink v3 debugger and programmer video. Thanks to STLink v3 set, you can seamlessly debug or program STM8 and STM32 targets in various ways. You just have to connect the STLink probe to a USB port of your computer and to your MCU target. You can easily debug and program your target using IAR Embedded Workbench IDE. STLink v3 will be automatically recognized. You should select it as a debugger, if not already done. You can easily debug and flash your target using Arm Keel MDK IDE. STLink v3 will be automatically recognized. You should select it as a debugger, if not already done. You can simply connect to your target using STM32 cube programmer utility. Thanks to this software tool, you can access information about your target, read and write target memories, modify options bits, and flash your application. The STLink v3 set is a modular tool. You can connect add-on boards to add new features. As an example, you can plug an adapter board bringing I2C, SPI, UART, JTAG and SWIM interfaces. Using the previously shown setup, you can connect and flash a target through SPI bus using SPI bootloader. You can find more details in the STLink v3 set user manual. For further details, check online at www.st.com-stlink-v3set. Thanks for watching this video.