Loading...

6576 | LaserTools Rack End Remover 3Pc

2,354 views

Loading...

Loading...

Transcript

The interactive transcript could not be loaded.

Loading...

Rating is available when the video has been rented.
This feature is not available right now. Please try again later.
Published on Jul 13, 2016

When removing the track rod to replace the inner ball joint, very often access is limited, and even if there is a hex on the inner ball joint you won't get a spanner anywhere near it. The new Laser Tools rack end remover tool (part number 6576), overcomes this access problem by fitting over the track rod itself and gripping the inner ball joint at the steering rack end securely.

‣For the removal and installation of the axle joint, track rod from the steering rack
‣The kit includes three seperate heads 30-35mm, 35-40mm, 40-45mm
‣Complete with drive shaft - length 405mm
‣Drive 32mm Hex or 1/2"D
‣Supplied in Blow Mould case

www.lasertools.co.uk

Loading...

When autoplay is enabled, a suggested video will automatically play next.

Up next


to add this to Watch Later

Add to

Loading playlists...