 So in this video, I'll go through mounting and resonating a photo. I just have a wooden panel and this printed zooli on photo paper. To mount it, I'll line up the print and clamp down one edge in place and then just lift up the print and use some spray adhesive. I cover the paper so that the glue from the edges doesn't roll onto the print when I brayer out all the bubbles. Then just take off the clamps, spray and brayer the other side. Now, the print's a tiny bit larger than the wooden panel so I just trim it with a really sharp knife. Okay, perfect. Time to resin. I mixed up about 8 ounces of art resin for this piece. That's a quarter of the starter kit. So I just poured it all over the surface and I used a little spreader to push the resin around. I rub the resin into the edges and it's just a tidy, easy way to finish the piece. A quick torch gets out all the bubbles. Then just cover it and let it sit overnight. That's it. Not too hard and you can uniquely present your photos like that. Try it out.