 we're moving right along as you can see we have our crossover mocked up real quick and pretty much almost done we got the blow-off valve on look at that Joker oh and what we got so far is this is gonna be our bong for bong for the IET sensor plugs in right there and then right underneath next to the blow-off valve we have where the water meth injection nozzle is going to be and pretty much it we got a three inch 90 degree elbow right here with some couplers we got put a couple more clamps on and then we have a I believe that's a four and a half to three coupler to go from the throttle body to the three inch stainless steel pipe that we used and this is just regular three inch stainless steel pipe that I actually had laying around from the past so that's what we used nothing special pretty much coming along looks good it's nice and solid not going anywhere pretty simple and clean install right here so we're gonna finish it up get some more clamps on here we got to get our meth and everything routed wired up and we're getting close to starting this thing so heck yeah continue on all right Mopar fam there you go torque storm supercharger completely on the truck we got our crossover pipe completely done we have the IET sensor inserted completely bolted in or screwed in blow off valve completely done we have it ran over here the side of the throttle body or the intake manifold right there and what we did there is we drilled a hole through the side of the intake and then I inserted one of these little barbed fittings I threaded that right into the intake and that is what's running our blow off valve for time being other than that pretty much we're almost done with this thing we're almost ready for a first start we still got to get in the meth nozzle right here and run the meth injection kit completely and get all that mounted up and we still have a boost gauge we got to mount up still but we're pretty much done guys almost there so heck yeah guys it's been a long day we are pretty much wore out but we made a lot of progress on project storm as you can see still a couple few more videos to drop like I said we got to get the boost gauge installed we got to get the water methanol injection kit from snow performance installed got to get the first tune in the truck installed and then we got to do the first start which is right around the corner so stay tuned don't forget hit that subscribe button and we'll see you guys on the next one