GB
Upload

Loading...

You're viewing YouTube in English (US).
Switch to another language: | View all
You're viewing YouTube in English.
Switch to another language: | View all

Installing a Yankee Hill free float tube

30,557

Loading...

Loading...

Transcript

The interactive transcript could not be loaded.

Loading...

Loading...

Rating is available when the video has been rented.
This feature is not available right now. Please try again later.
Uploaded on Mar 14, 2011

This video shows me installing a Yankee Hill free float tube. It was an easy go but I highly recommend buying the block for the front sight base. Taking off the FSB was the hardest part of the whole process. Instructions below

Apparently there are some guys out there who must know everything about building guns, however, they are confused.

From the instruction sheet:
Screw the barrel nut onto the upper receiver until it is tight by hand. Using our forearm wrench (YHM-9621) tighten the barrel nut until the next gas tube hole lines up with the upper receivers gas tube hole(using a rubber mallet). Take special care in aligning the gas tube hole in the receiver to the gas tube hole in the barrel nut. See diagram to the right.

http://yhm.net/pdf/Install_Freefloat_...

As you see, there is nothing included about torquing down to 30 pounds.

Loading...

When autoplay is enabled, a suggested video will automatically play next.

Up next


to add this to Watch Later

Add to

Loading playlists...