The Y-Not A/B/Y Switcher

This video is an introduction to the Y-Not A/B/Y switch. This switcher, by RJM Music Technology, allows you to switch between two amps using MIDI or a simple 2-button footswitch. The video shows us using the Y-Not to switch between a Fuchs ODS Artist amp and a modded Marshall Plexi reissue. A Line 6 POD X3 Live is used to control the switching and to provide effects.

Category:

Music

Tags:

• RJM
• Music
• Y-Not
• Ynot
• ab
• switch
• aby
• a/b/y
• a/b
• fuchs
• ods
• marshall
• plexi
• crunch
• mod
• la
• sound
• design
• pod
• x3
• live
• line
• guitar
• effects
• switcher
• midi
• rig
• switching
• system

[PlutoWilson]

I am setting up a GCX switcher and Control Pro. I am now learning of a hum problem. I am using an old modded marshall and a holland no fx loops on amps. I am going to run effects pedals in a rack with my gcx switcher and may need to use this Y-NOT to shield my sound from hums, etc. How would I do this so the controller would operate the switcher and the Y-Not so I can create presets with different channels and effects?

[rjmmusic]

@PlutoWilson If you start with the factory default configuration of the Ground Control, then turn on GCX1 in the controller setup, the Y-Not will work pretty much right out of the box. To program, just select a preset on the Ground Control, then select A, B (or both) on the Y-Not, then hold down the write button on the Y-Not until the lights flash. The Y-Not will remember the settings and will bring them up when you recall that preset on the Ground Control. You can do this for up to 128 presets.

[madamkirk]

Beautiful tone! Hey I know it's complicated with all of the possibilities but this video doesn't actually play music until 5 minutes of talking is done!

[itsGoboboy]

Hey, thats a cool switcher. I was wondering if you would do a video just demoing the crunch mod on that plexi. I was thinking about getting that mod and I want to hear how it sounds.