Molten Voltage Tempo~Wave LFO Sequencer Chip MV-53

Tempo-Wave Sequencer LFO Chip MV-53 represents the state-of-the-art in analog waveform generation. By outputting an ultra-clean analog signal, MV-53 can control Phasers, Wahs, Tremolos, and any other type of circuit that relies on low frequency oscillation. All this is done using extremely precise digital controls. Features include: *Analog waveform generation at a 1.23 MHz sample rate, output by an on-board Digital Analog Converter [DAC]; *Four different waveforms: Square, Sawtooth Up, Sawtooth Down, Sine; *Four different playback rates: 1:1 [real time], 1:2 [double time], 1:3 [triplets], 1:4 [quadruple time]; *Wide playback speed range of .033 seconds [1818 bpm] to 13 seconds [4.6 bpm]; *Waveforms, rates, and speeds can be switched seamlessly "on the fly"; *Programmable with sequences of waveform and rate combinations of up to 16 steps, stored in nine (9) non-volatile memory locations; *Simple to program; *Switchable between two different speed controls: Tap Tempo (accurate to better than 1/1,000th of a second) and Potentiometer-based; *Dual simultaneous waveform output (one is inverted); *Duty Cycle Control with 11 different musical ratios that can "swing": 1/8, 1/6, 1/4, 1/3, 3/8, 1/2, 5/8, 2/3, 3/4, 5/6, 7/8; *Real-time LED interface; *Easy to defeat unwanted features. Follow this link to find out more: http://www.MoltenVoltage.com/mv-53.html

Category:

Science & Technology

Tags:

• Low
• Frequency
• Oscillator
• Oscillation
• programmable
• LFO
• tempo
• wave
• sequence
• Molten
• Voltage
• chip
• MV-53
• program
• duty
• cycle
• effect
• guitar
• synth
• circuit
• schematic
• DIY
• boutique
• pedal
• electric
• uC
• microcontroller
• custom
• tap

[sonnyfood]

So you have to build your own pedals if you want to use this?

[MoltenVoltage]

@sonnyfood

Yes. There are schematics on our website.

[Youreallysuckguy]

Amazing ! Is it available ?

[MoltenVoltage]

The chip is available on our website along with a detailed datasheet and schematics.

Thanks!

[Youreallysuckguy]

Can I find the TS9xx component easily ?

[MoltenVoltage]

It available through Mouser, but any 9 volt rail to rail op amp should work.

[sonnyfood]

@MoltenVoltage That's a little over my head I think, but I love the video. Your products are really unique and I dig that. I hope to see more stuff in the future!