BMW M44 on twin side drafts

I built a wasted spark setup for my M44. I used wasted spark coils off a toyota, A programmable single channel ignition kit from Jaykar does the control of ignition table. By using the factory Hall effect sensor we can toggle the output of the ignition controller to switch the coils for cylinders 1 &4 to fire cylinders 2 & 3

Category:

Autos & Vehicles

Tags:

• bmw
• m44
• wasted spark

[11BMWpower11]

would have been much more effective on a 2.1L big bore M42. The M42's crank can handle higher RPMs because its balanced better.

[62rot]

@11BMWpower11 what pistons do you use to get 2.1

[11BMWpower11]

@62rot May just be a stroker kit, my mistake. Many people have done it on forums etc. One shop used to make a stoker kit for the M42 but its now unavailable. Very nice set up by the way haha, Im very jealous. I just put a M44 in my E30 ;)

[62rot]

@11BMWpower11 I have heard about it but I wasn't to sure if they used the M42 or M44 crank, I have a few M42. Just looking for pistons to be uesd

[ape20ff]

Hello. What about the module for the wasted spark ignition? I couldn't find it on

nzefi.co.nz

Thank you.

Kind regards

[bigfyshy]

@euroe30 Carbs... Not ITB's

[euroe30]

What itb setup is that? or is it custom?

[donoddvar]

will this kit be used in car ore is it just to get engine running out of car? thanks.

[jessellanos787]

well done dude i want one to haha but great job

[RedPolack]

that is really smart keep up the good work BMW 4 life!!