Blade 450 tail rudder issue.
Loading...
Loading...
338
views
Loading...
Uploader Comments (HalfNakedGUCCI)
see all
All Comments (3)
-
Movement on the sticks are correct and that heading hold usually does that, but the compensation is going the wrong way. On a rate mode setup on the gyro it would go back to center.
Loading...
12:13
Blade 450 3D Mechanical Setup tutorialby bladehelis11,334 views- 2:48
Jeremy Hodak / Rave ENV nitroby EclipseHobbies228 views
- 3:04
Blade 450 X... goofing off!by MikelG09,687 views
- 0:53
Blade 450 soft start spool up. Perfect tracking and balance.by radiocontroldoctor19,657 views
- 9:07
E-flite Blade 450 Unboxing & Maiden Flight!by earthling198418,031 views
- 2:08
Blade 450 First Flightby HalfNakedGUCCI168 views
- 1:42
T-Rex 500 tail wag at first hoverby sirenp36,243 views
- 1:41
exi and rc heli tail drifts or if heli spins solutionby wcwickedclown1,368 views
- 1:23
Blade 450 3D on Phoenix simby amorgan111713 views
- 6:37
Blade 450 3D - Beginner level FPV - No vibration!by kooleco7,547 views
- 2:17
Blade 450 3D Stock Helicopter Flying, E Fliteby winstone24193 views
- 4:31
Blade 450 3D_Wapelhorst Park_Zoomedby PULSE1994KCMO520 views
- 2:17
E-flite Blade 450 3D over water & trying to catch a fishby earthling19846,372 views
- 4:12
Primeiro vôo com o Blade 450 3D [HD]by RCBRHelicopteros305 views
- 4:11
Eflite Blade 450 3D - Almost maiden flightby Locoracers575 views
- 1:10
trex 450 tail blade failureby cobradude2009462 views
- 6:18
Blade 450 3D - More beginner level FPVby kooleco669 views
- 1:34
Blade 450 Front flips and Back flipsby highadvantage142 views
- 10:14
blade mcpx ,how to fix vibration problems and tips on set up.mp4by nitrokyosho12,290 views
I believe that is normal with a heading hold gyro. It is trying to compensate becasue the tail did not move in the direction it was supposed to.
If you reduce your gyro gain on your transmitter to 50 or below, it should center like you are expecting it to.
wbefield 3 months ago
@wbefield A few things were wrong, my gain was set up too high, the switch was stuck in the. My gyro needed to be power cycled IE switched on, the dip switch flipped, switched off, then the dip switch back to normal position, then Everything was ok :D
HalfNakedGUCCI 3 months ago