Saito FA-80 Four Stroke
Loading...
Loading...
8,716
Loading...
Uploader Comments (mastmar)
see all
All Comments (7)
-
@7bikerboy7 no unless its up side down
-
Cool vid...I have a question...Im now breaking in a os fs 120III 4 stroke. The instructions say i dont need the line from tank to muffler, what do you think?
-
prop size and RPM? sounds nice and steady...
Loading...
1:01
Saito 170R-3 3 Cylinder Radial Engineby workonesabs35,954 views- 0:36
New A6M5 Zero with Saito 170R radial initial runby GAZZERPOPE41,602 views
- 0:45
OS ENGINE 4 STROKE - Motor 4 tiempos -by tagger2000188,287 views
- 0:27
Saito FA.56CL Break-in run.by StuntPilot886,374 views
- 1:04
Saito 100 first startby Tagen2427,426 views
- 4:16
Hanger 9 rc p 51 mustang 4 stroke saito 80by wibble19641,846 views
- 0:49
Saito FA-90T twin four strokeby mastmar7,495 views
- 7:05
New Ryobi 4 stroke glow conversionby tlareng19,438 views
- 2:59
Motor Test: O.S. FS-200S 4-Stroke Glow Engineby rcsportflyer16,090 views
- 1:50
Sea Fury with Saito 120by robbo11a4,029 views
- 1:25
Saito 82a.wmvby ThtY34,101 views
- 1:52
90'' RC P-38 lightning crashby Flyboy2581,157,787 views
- 0:44
Saito 80 on a Sig Astro Hogby cherokeenut891 views
- 2:29
Hangar 9 showtime w/saito 82by dudesaweeeet7,854 views
- 2:33
Engine Test: YS 170DZ Four-Stroke Glow Engineby rcsportflyer4,966 views
- 2:51
Saito FA-82a Golden Knight 4-Stroke Glow Engineby rcsportflyer3,973 views
- 2:54
Saito FA-180 Bench Runby rcboatmaniac9,448 views
- 3:32
Four stroke nitro engineby b7619977,640 views
- 5:02
HD MY Hanger 9 Funtana X50 with saito .82 and ASP .80 at PRAMSby redcatster2,838 views
Cool vid....I have a question.i just bought a mustang with 4 stroke os 120 with spiiner and when i was trying to breakin the engine i seemed to have stripped the back part of the spinner backplate now theres not much for the engine to grab onto.Whats the fix for this? should i tightn the nut extra harder to keep the prop from moving?
7bikerboy7 2 years ago
I assume you have a good quality spinner... Since the motor shaft is hardend steel, I crank the nut as tight as I can with a standard prop wrench. I just about crush wooden props. Yes! tighten it extra hard.
mastmar 2 years ago