Making a Propane Forge II
Loading...
Uploader Comments (stellajoylincoln)
All Comments (19)
-
@sevenswanstudio He said it was a Kilm Shelf they are diffrent the firebricks
-
what blade did you use to cut the fire brick, I have so much fire brick laying around and i tried to cut it with a concrete 12 inch cut off wheel, And it took forever to cut it.
-
What website did you get your ceramic fiber insulation from?
-
@hammerfistforge you can get it from an industrial insulation supply store. fyi-after ceramic fiber insulation has been exposed to high temps it becomes highly hazardous healthwise-similar to asbestos.
-
where do you get the insulation from? basically what kind of store?
-
Yes, you are correct. I forgot to mention that I was going to coat the kaowool with ITC-100. Thanks for catching that. I will add a note at the end of the video to do that.
-
You really MUST seal that ceramic blanket with satanite or rutlands. If you dont, you will be filling your shop and lungs with asbestos-like fibers when it comes to heat. Trust me, I am a bladesmith, it is a serious hazard. Coat with satanite and then Kast-o-lite for durability and then itc-100 to make really efficient. You can skip the last two if you don't weld with borax flux.
-
yes, most are not
-
Are you sure air compressor tanks aren't galvanized?
1:19
Propane Forge III |: first fireby stellajoylincoln21,172 views- 2:02
Making a Propane Forgeby stellajoylincoln83,336 views
- 0:15
DIY Propane forge.mp4by Greenbeast9991,756 views
- 7:08
Forge Construction 13by mintwart7,571 views
- 0:41
Propane Forge IV |: first fireby stellajoylincoln12,613 views
- 2:43
Home built foundryby 8MADJACK456,931 views
- 0:52
Home made propane forge pt.1by shortfusedleathernk8,123 views
- 5:05
Brake Drum Forgeby TheHarleyhillbilly44,918 views
- 1:02
Scrap Steelby julian60329,463 views
- 5:16
natural gas burner for forge/potby HomeDistiller23,728 views
- 7:39
Build a Simple Forgeby JBThunder2000132,661 views
- 2:08
Blacksmith Single Burner Gas forgeby vid170711,493 views
- 2:08
my propane forgeby darkslyde50419,712 views
- 9:51
How to build a Babington Burnerby OilBurner2008256,563 views
- 1:45
New Burner Designby lkcnlkngf29,461 views
- 3:11
EISENKRAFT® FO Forge Ovenby doenitzman10,263 views
- 0:32
Mini forjaby joalexvoss33,006 views
- 4:13
Making and Testing a Home Made Forgeby Ghostkamo29,151 views
- 1:08
Mini hydraulic forging pressby TAToler75,197 views
The fire brick is made by Therma Ceramics. It is a insulating firebrick which is very light and fragile. It's very much like pumice and can be cut with a hand saw. I would recommend you build a frame around this type of brick otherwise it tends to fall apart. This fire brick is so insulating you can put your hand on the outside of it after running the forge for hours. Good stuff but requires TLC.
stellajoylincoln 9 months ago