Transformers Masterpiece MP-10 Convoy Optimus Prime Review Part 2
Loading...
2,537
Loading...
Uploader Comments (MisterFanwank)
see all
All Comments (13)
-
im gonna get one of these bad boys, my gape about would be that there is no leds for the matrix in the chest, and the hands havent been upgraded in general of the mp line.the hands should have balljoint or hinge wrist and each finger should be on balljoints as well, but over all it looks great
-
@archienov Thanks.
-
@MrSpencerprime Actually, the height of MP-10 in robot mode is just a little over 9 inches. He's around 245mm to be exact according to the packaging.
-
Great review dude thanks
-
Thanks for showing the trailer with ROTF OP.
Loading...
Is it possible for you to measure him for me? Just put it in comment form. If you could, just measure him in vehicle mode without the trailer and then in robot standing straight. If you could, it would help me a lot. Thanks
MrSpencerprime 4 months ago
@MrSpencerprime I do not have him with me right now, I have shipped mine back to BBTS for a replacement. In robot mode he's a little over a foot tall, and about six or seven inches long in alt mode. Those measurements are just based on my memories of how big he was, so they might be a little off.
MisterFanwank 4 months ago
Great vids on the MP10 dude!!! Thank you! Only thing is I disagree on the trailer turning into a box. I know I don't want to see that, I doubt many do. lol
ShartimusPrime 5 months ago
@ShartimusPrime I was just thinking that may be a good way to give it a "transformation" that's more than just opening up into an OK looking base. It would save on shelf space, which is the big thing for me behind that idea.
MisterFanwank 5 months ago
Nice video buddy. You made error with Gun to Roller connection gimmick. :D
wewyllenium 5 months ago
@wewyllenium I tried putting it into the hole at the top of the trailer hitch several times, but the pegs on the side of the handle Prime uses to hold it are too wide. There's a slot in the back of the trailer hitch that is perfectly sized for the trigger and the back piece applies pressure to the side tabs, making for a fairly solid connection. I could be doing something wrong, but this seemed to be the best way to do it.
I'll look into it some more later today.
MisterFanwank 5 months ago