Intek MT-5050 Mod with beep

I have two Inteks and both have a beep in the mod.
The beep changes when you touch the antenna.
This is not an acoustic feedback!
Is this normal for that devices?
My Stabo 450 don´t beeps.

Category:

People & Blogs

Tags:

• Intek
• MT5050

[v0rgixxer]

Just sent you a private message.

I have a mt5050 with the same problem. Can you help me?

Thanks.

[DT125ccm]

@v0rgixxer

Yes I solve it - I bought a Wouxon KG-UVD1P ;-))

[toiosoiovoio]

Isn't that feedback ?

[DT125ccm]

No, sadly not.

I´m not that stupid ;-)

It´s not with LPD-Frequency and high power.

[XXtremeDrummer]

It's simply some LARSEN due to the small distance between the transceivers!

[Pyromaceno1]

@robblac to switch to and from rechargeable Ni-MH and alkaline battery's at a guess :)

[robblac]

anyone know what the tiny  switch under the far right battery marked "al ni" is for ?

[robblac]

i would guess that now they are pumping 4 watts out, your pissy little antennas are causing this RF effect, do the SMA antenna connector mod as well, should be fine

[cornz38]

The issue will dissapear if you fit the properly tuned antennas..Not the springs that they are supplied with. Check out my antenna mod vids on here.

[Schnarchnasen]

i have some stabo freecom 450 and i sounds the some with them. but when i transmitt with the stabos, there is no sweep-tone. the beep is with low and high power.

[magicthekitten]

have you tried them at a sensible range apart yet??

[Schnarchnasen]

Hi,

yes it`s high (ex-version).

it´s not a feedback!!

The effect is the same when the devices are 10m separated but this is hard to put in the movie...