HOW TO TUTORIAL - Why R/C Car doesn't move-Wheels only spin when held above ground

Well after many people emailing/PM/Commenting to me that they had this problem, where the car would hardly move, the engine would rev high but the car would hardly move, but the wheels would spin like normal when it is held above the ground. So here is the long awaited tutorial on what to check for, and how to fix it. Remember that you can email me to jt12rchelp@aol.co.uk and add me to your MSN using that address as well. Cheers and stay tuned to http://www.youtube.com/jthornley12 and also http://www.youtube.com/jthornley12how2s

Category:

Autos & Vehicles

Tags:

• RC Car wont move
• Why RC Car doesn't move
• RC Car wont move problem
• Problem
• How to tutorial
• Fixing process
• How to fix this problem
• Nitro Car wont move problem
• Nitro Cars
• RC Car problems
• Nitro RC
• Remote
• Radio Controlled RC Vehicles
• RC Vehicles
• Jthornley12
• Jthornley12how2s

[85miles]

great vid but your camera focus is annoying

[jthornley12]

@85miles Agreed, well camera was replaced years ago

[sukhdip1997]

hey, i tried to tighten th enut on the spur gear, and the spring like thing would  un-tighten it. what should i do?? :(

[jthornley12]

@sukhdip1997 If you try to tighten it, why would it Loosen? unless you are turning it the wrong way?

[123hobao]

i was driving my nitro rc today a thunder tiger tomahawk st and i think i over filled the fuel tank so i started it and it went full throttle lookerly i was holding the spoiler so it dident crash but know it wont start the glow plug was bright red so thats burnt out and when i press the throttle nothing happens but the wheels turn any advice anyone

[jthornley12]

@VideosOfTodayTV Ok mate, good luck with getting it fixed ;)

[VideosOfTodayTV]

@jthornley12 Thanks for your reply.

I might just call to the near hobby shop and get it fixed.

Thanks anyway

[jthornley12]

@VideosOfTodayTV Might be the Grub screws in the Drive cups loose. Check n Tighten/replace

[jthornley12]

@VideosOfTodayTV I don't see how I can help. There will be a hole :) not much else I can say mate