Esky Big Lama With Long Shaft To Prevent Blade Strike

Test flight on big lama with extended long shaft

Category:

Howto & Style

Tags:

• esky
• e020
• big
• lama
• with
• extended
• long
• shaft

[milestrina]

repaced extended long shaft, but no lift off, any suggestions?

[technoelect]

@milestrina Could it be the A and the B blades you have wrongly installed?

[nonames000]

Can somebody please put a how to install this on youtube

[thefish1995]

hahaha long shaft../...

[technoelect]

from miracle dash mart

[technoelect]

@elandresito

from miracle dash mart dot com

[elandresito]

@technoelect where can i get the etended shaft?

[technoelect]

@primalspy

It had slightly more power than the stock motors. It is your preference because i found the stock motors quite powerful too. I have not use 3d pro blades before but i have used the Airy hardened blades. It will still break if there is a hard crash. Miracle dash mart dot com have few version of Big lama blades and you can try it out.

[primalspy]

@technoelect Thank you for getting back to me! : )

I'll have to take that into consideration about the overheating. I think that for now, I may just place a couple heat sinks on the original motors to help prevent overheating. Do the Xtreme 180 motots out-perform the stock Esky 370 motors? Have you tried the 3D pro hardened blades?

[technoelect]

@primalspy

I have tried that but found the main board driver ICs was quite hot! When i put back the original motors, the ICs were warm only and not hot. I believe if we use the Extreme 380 motors, add in bigger Mah battery and bigger blades, the control board ICs will surely blow. I am satisfy with the original motor because it already flew very fast and after dozens of flight the motors are still good in condition.