2005 2009 Mustang 4.6 GT Mustang BBK Performance Pulley Kit Installation Video and Dyno Test

http://www.bbkperformance.com/products/performance-pulley-kits/sfi-performanc... - Check us out on facebook here: http://www.facebook.com/bbkperformance
Watch Part 2 of the Muscle Mustangs & Fast Fords 2005-2008 "project" Mustang GT Series. Watch as the MM&FF editors upgrade their mustang with some of the best performance parts available.




This part of the series shows the installation and testing of a set of BBK Aluminum under drive pulleys on a 2005-2008 Mustang GT.

Category:

Autos & Vehicles

Tags:

• mustang
• muscle mustang
• fast mustang
• performance mustangs
• dyno testing
• pulley kit install

[rb33rams]

do i need to torque it if i used an impact wrench. I did as how it was done in the video with the air tool. can the bolt be overtorqued and if so can it cause problems?

[bbkperformance]

@rb33rams- It's strongly recommended to use a TQ. wrench.

[Drifterzz89]

Hey do i need to tune the car after installing the underdrive pulleys ?

[bbkperformance]

@Drifterzz89 No tune required.

[Turbo05gt]

Idk...

[TheJimgonzalez]

For the novice here... I am confident about doing this myself. However I noticed that you removed some additional items, or was it just one i.e. the reservoir for the radiator? so was it the electric fan and the water reservoir and that's it. Also on a final note, do you need to disconnect the negative battery at all?

[rb33rams]

i had a question. I installed the bbk pulleys on my s197 but did not torque the crank bolt on the pulley, just did as how it was done in the video with an air impact wrench. Do i have to go back and torque it or if its fine should i leave it like that, also can the bolt be over torqued causing some problems?

[mustangwner2003V6]

BBK Has alot of products for v6 mustangs, I pretty sure they have a website still, if they do I will e-mail it too you on youtube.

They are a great company for the v6.