How to maintain your PWC

This video shows you the minimum you need to do after each ride! If you have a SeaDoo, you still need to flush.
Do not waste your time on trying out different kinds of rust inhibitors, get Fluid Film aerosol can and enjoy a rust free ski for years to come! You can even wax your ski with Fluid Film to avoid getting hard water spots such as what everyone experiences at Lake Havasu.

Just a note, do not spray your engine if it is hot. Let the engine cool down before hitting it with water.
Subscribe to Captains Aviation if you like what you see! Any questions, don't hesitate to ask!

Category:

Sports

Tags:

• fluid film
• Reza
• Captain
• HO
• Gholamipour
• How to
• PWC
• seadoo
• SeaDoo
• Kawasaki
• Flush
• Flushing
• hard water spots
• lake
• Rust Inhibitor
• Best Corrosion Inhibitor
• Preventive
• Post Ride Check
• Yamaha FX HO Cruiser
• How to maintain your jetski
• waverunner
• wave
• runner

[Metalunique]

Do u have anything on engine maintenance. cable lubing or pump care?

[CaptainsAviation]

@Metalunique which pwc do you have? I am thinking about doing oil change video and anything I can to help!

[mattywilson76]

I usually dont like or comment......But that was one informative vid....5 stars

[CaptainsAviation]

@mattywilson76 Thanks Mr. Wilson!! I appreciate you did!

[dix0n001]

hi water is coming out the back like it should with the bike ran on the hose it never gets warm/hot but in the video you have posted it says there should be water coming out of the pisser port look at minute 3.23 on you video clip to see the bit i mean .My problem is im not getting any water out just the odd spit every now and again is this ok or do i ned to get it looke at

[CaptainsAviation]

@dix0n001

Well, there are couple of things, your water pressure may not be high. Rev the throttle to about 3K for few seconds and let go and see if that helps for a more consistent water flow. I would not worry about it if you are not over heating when riding the ski. I bet its due to water pressure off the hose if you don't have any dirt/sand stuck in the hose. You can always disconnect that hose and blow some air through it, make sure it is clean! If it is then don't worry about it much!

[Metalunique]

@CaptainsAviation 92 kawasaki 750sx.

[Metalunique]

Great tutorial. Thanx for sharing. I learned a lot from this.

[dix0n001]

ok thanx for your time and replys

regards

paul

[CaptainsAviation]

@dix0n001

If you are getting water coming off of that, it's great but you also have to have water coming from the back of the ski. Do you get water coming from the back of the ski or the port pisser is the only place you get water coming out? Sorry, I am still unsure what exactly the problem is.