CorkSport 2010 Mazdaspeed 3 Cat Back Exhaust + Racepipe

Sound Clip of the CorkSport 2010 Mazdaspeed 3 Cat Back Exhaust plus Racepipe

Category:

Autos & Vehicles

Tags:

• Mazdaspeed 3
• Cat Back Exhaust
• Racepipe
• CorkSport
• Mazda Performance
• MS3
• CBE
• Test Pipe

[CorkSport]

They are Yokohama Advan RZ wheels. We went with 19 x 8.5 inch wheels with a +45mm offset.

[CorkSport]

We made some slight revisions to the cbe a while back to lower the volume some.

[ziosrips]

also getting the AP tuner you can see where your pressure drops to im holding up atm just at 1700 1699 under boost so i know the exhaust will be the final mod. This point its borderline when the fuel pump cant push the pressure anymore...

[ziosrips]

I just removed my racepipe do to the car running to lean. I have a few mods on the car so that could be why also. But im telling you the best thing to do is wait on removing the cats until you buy internals for your fuel pump or just replace it with a HPFP and all problems solved. I should be receiving the NGK laser cut one step colder spark plugs on thur and fri install. Then i only need the CBE from corksport to be full stage 1.

[downsidefx]

hm, thanks for the advice. I'm not sure I'm ready to spring for the DP yet, I actually emailed corksport and they said the CBE+race pipe should be fine without any tune or fuel internals upgrade. Once you add the downpipe, then its absolutely necessary. I was planning on getting the forge bpv, haven't noticed any boost leaks really but a lot of people have said the stock doesn't hold as it should.

[ziosrips]

actually you cant put your racepipe on without have a HPFP high pressure fuel pump. Soon as you start to remove either your second cat or downpipe fuel pressure drops. My advice to you is buy the fuel pump then you AP tuner from cobb and downpipe and Forge BOV then you will be able to rock stage 2 with no worries about leaning out or blowing your turbo or whatever else comes from the car being starved for gas..

[downsidefx]

I currently have the CS SRI+TIP and CS Racepipe. If I purchase the CBE, will I need to upgrade any of the stock components or require a tune for the car to run well? Or can it just bolt on and be good to go? Thanks, love your products!

[NissanDrifterS14]

can you tell me what kind of rims those are, and also the size, i have a 2011 speed 3 too and it would look dope with those wheels

[painfulpillow]

Nice sound, so is this a new item that is coming out or revising the existing exhaust?