Keg to Kettle Conversion (part 2)

xylene w/o gloves. yikes.

How high up is the hole above the inside bottom of the keg?

Are those boots brahmas ? lol

I am so excited to convert my keg that I am getting as a freebie on monday!

I did forget the safety glasses on this one. My mistake. Leather gloves are a little over the top for drilling sheet metal, though.

Great video, but lack of safety equipment! Leather gloves and eye protection are a must folks! You never know when a shard of metal will fly off!

safety sam says "allways wear safety glasses whne drilling"

I'm convinced that a bimetel hole saw is easier now that I see the step bit in action. Cheaper too;-)

I tend to disagree. Though hole saws are cheaper, they tend to dull quickly. I DESPISE drilling stainless (and most other metal) with hole saws. The step bits give you very precisely sized, almost perfectly round holes, and they don't dull nearly as fast. Personal preference, I suppose.

Yuri, nice work on the "ethically" located keg.