Upgraded Lionel C&O Berkshire
Loading...
Loading...
2,395
Loading...
10:08
Lionel Legacy Nickel Plate Road Berkshire 765by Railroadtrip4458,354 views- 9:58
Lionel Layout Full Operationby JC2341132,188 views
- 1:48
Lionel Legacy C&O 2696by Railroadtrip4455,717 views
- 1:16
The most AWSOMEST engine EVER!!!!!!!!!!!!!!!!!!!by trainkids7,011 views
- 10:49
Lionel Baltimore & Ohio EM-1 2-8-8-4 #7616by bigsteam53445,350 views
- 1:15
Lionel C&O Berkshireby gdp19621,831 views
- 0:41
O-scale Chessie Steam Specialby adadelman2,597 views
- 6:39
Polar Express Christmas 2010by sunfiregts319,047 views
- 1:01
Lionel Berkshireby trainbros8910,421 views
- 2:23
Alleghenyby adadelman2,384 views
- 0:35
Lionel C&O 2699 Berkshire runningby Chessie90095,666 views
- 9:22
The Run of the Lionel Legacy C&O 2696 Berkshireby Railroadtrip4454,733 views
- 0:23
Chessie Steam Special Slow Runby adadelman6,361 views
- 9:50
Lionel train set in progress 2007by gdahl230,970 views
- 1:37
My Rio Grande Berkshire setby ssstnh19962,622 views
- 3:28
Lionel TMCC Nickel Plate Berkshire Demonstration Run With Legacyby trainpeeps2,467 views
- 1:16
Listman O Scale Layout Part 9by Train9632W251 views
- 2:20
Nickel Plate Berkshireby mkostur12,704 views
- 1:20
C&O Berkshireby vbkostur2,896 views
- 1:42
Listman O Scale Layout Part 8by Train9632W331 views
where did you get this upgrade!?!?!?!
Chessie9009 2 years ago
Sorry I did not get back to you sooner - I did not get a notice of the comment. What I did was use a Digital Dynamics chuff sensor and four magnets which I ground down to fit in the recess of the driver to get the 4 chuff's per revolution. The chuff sensor got connected to the same two wires that the existing chuff sensor was connected to (that I removed).
adadelman 2 years ago
was it hard to do?
Chessie9009 2 years ago
Not too bad. The hardest part was to take the small magnets and grind them down to half circles so they would fit in the wheel well. Once that was done, gluing them in place was not hard. I then glued the sensor so it would be triggered by the magnets. Soldering the sensor to the wires I removed from the existing sensor was the easiest part.
adadelman 2 years ago