Electrolysis Cell Hydrogen Oxygen

Electrolysis cell running on 100% tap water 12 Volts 35 amps.
12 Sainless plates
20mm X 10mm X 2mm.
Watertemperature ca 80C°.
Sadly only 3 of 6 positive plates are working.
I have discovered The most efficient way to elektrolysis, is at a tempeature of 99c°
Remember your water cooker.
When water gets near 100 c° you can see bubbles rising up to the surfice.
These bubbles are build of 50% hydrogen and
50% C0. Those 50% of hydrogen gets connected with the hydrogen of the elektrolysis. Think about it.!!!!!.
You can run your cell at temperatures near 100c° it is no problem.
The only think you have to do is, you must flow your hot steam through a water bubbler to seperate the the water from the steam.
It is important.!!!
You will discover a huge amount of gas, you have never seen before.
Here is definitely more energie comming out than putting in.
12 volts and 35 amps is 420 watts.
Each altenator can handle it
Look at the bubbles there.
It is absolutely way more energy embedded in the bubbles.
Dont belive in everything you have been supposed to belive !!!!!!!

Category:

Science & Technology

Tags:

• Elektrolysis
• cell
• water
• fuel
• reactor
• Joe
• Cell
• Stanley
• Meyer
• Water
• car
• Hydrogen
• Oxygen
• Brown

[rblackwell2771]

i noticed the tap water i use from town causes pitting on the plates and a lot of brown muck. some type of water treatment i suppose. I don't add anything else.

[rblackwell2771]

i like using rainwater or from a creek.

[massware]

So, the electrolytic cell must be on a box where the hot water from motor can be circulate around and transfer the heat and improve electrolysis. One more thing: We can after that on this cell broke in H2 +O2 the produced steam also!

[Perspektyva]

Agree, lots of unwanted substances get broken down, some of which might be even poisonous.

[MrLeN76]

Don't use tap water.