Grex P650L - 23 Gauge Headless Pins - A Better Way to Join Wood
Loading...
Loading...
10,464
Link to this comment:
Share to:
Uploader Comments (grextools)
see all
All Comments (4)
-
@hydeph thank you ---- I'll take it back and see if they give me a new one --- I'll let you know.
-
@billfromelma sounds defective, yes, i had a MAX brand nailer which is identical to this, and it sunk pins 1 inch and longer in maple and hickory - pine should not be an issue
Loading...
- 2:30Grex P650 - 2" 23 Ga. Headless Pinnerby grextools430 views
- 2:07Moldings, Finish and Trim with Gary Striegler -...by grextools1,597 views
- 2:57Dowelmax Jig - Joining Long sectionsby criticalrabbit9,677 views
- 1:21Grex Green Buddy 18 Gauge 2" Brad Nailerby grextools2,223 views
- 6:53Moldings, Finish and Trim with Gary Striegler -...by grextools1,718 views
- 4:16GREX Headless Pinners Presented by Woodcraftby woodcraftmarketing3,121 views
- 4:15PORTER-CABLE Pneumatic Nailers & Staplersby irachelh22,073 views
- 4:06Moldings, Finish and Trim with Gary Striegler -...by grextools640 views
- 2:43Woodworking Tips- how to make a half jointby flavpops26,367 views
- 4:11Blue Jeans By Jessie Jamesby scandalous360558,630 views
- 3:17Grex Adds Rapid-fire Feature to Upholstery Nailerby WoodworkersJournal2,175 views
- 4:20WoodChoppinTime QUICK TIP: Join Edgesby BigChopperoo4,779 views
- 3:03Triton biscuit jointer - joining long boardsby ijerry145,713 views
- 2:41Grex 23 Gauge Pinner Pneumatic Nailerby homefixated758 views
- 9:16Part 33-6 Installing Rudder and Trim.wmvby redbarnboats1,114 views
- 1:37Premium Woodscrewsby smaxwell1963862 views
- 8:29The Dowelmax Precision Engineered Wood Joinery ...by woodcraftmarketing8,545 views
- 8:19Woodmaster Curved Molding with Gary Strieglerby woodmastertools38,983 views
- 3:33Demonstrating the Festool Domino Joiner DF 500 ...by toolsandmachinery4,104 views
so I bought one of the 650s (not the L with the override )---- used it on some door casing ---- just plain ranch casing --- pine --and I found it had a hard time sinking the pin below the surface. I had the compressor up to around 100psi . I know it says to use the 650 @ 120 psi for hard woods but this was just pine. what do you think -- do I have a defective unit?
billfromelma 1 year ago
billfromelma, thanks for your comments. Insufficient air pressure is the most common reason for not sinking pins below the surface. If you're driving pins longer than 1-3/8", we recommend 110psi. The second most common reason is if the tool is allowed to bounce when driving pins. Make sure the tool is held down firmly. Because the fasteners are so fine, its more crucial to prevent bouncing in order to set pins below the surface as the tool should. Feel free to contact us directly at 888-4GREXCO.
grextools 1 year ago