MAKING A COMPLEMENT FOR DIAL GAUGE PART 1 of 2 "HD"
Loading...
Loading...
11,597
Loading...
9:47
MAKING A COMPLEMENT FOR DIAL GAUGE PART 2 of 2 "HD VIDEO"by tryally8,367 views- 8:55
Making a micro tool holder part 3 of 3 "HD"by tryally15,434 views
- 0:53
Build Your Own Toolchanger 1by jwvica0113,929 views
- 0:20
lathe issue?by outfitter19540,086 views
- 7:36
Making an end mill holders part 2by tryally20,313 views
- 9:28
Making a micro tool holder part 1 of 3 "HD"by tryally13,394 views
- 10:01
Making a micro tool holder part 2 of 3 "HD"by tryally12,496 views
- 7:54
Tryally Technology with Sherline IIby tryally6,242 views
- 9:57
SHARPENING A MICRO TOOL Part 2 of 5 "HD"by tryally11,759 views
- 4:16
Tryally Technology with Sherline IVby tryally6,896 views
- 9:17
SHARPENING A MICRO TOOL Part 1 of 5 "HD"by tryally34,354 views
- 8:39
Tryally technology with Sherline V part 1by tryally6,155 views
- 9:17
End mill holders part final 2-2by tryally12,443 views
- 0:33
Z90P CNC Router - Dial Gauge test at 10,000 mm/ min From £1460 +VATby RoutoutCNC9,981 views
- 9:42
A small platform to tailstock part 2 of 4by tryally1,931 views
- 9:55
My Sherline Vid 1by Setharoo212,682 views
- 10:00
MODIFYING THE TAILSTOCK Part 2 of 5 "HD"by tryally4,388 views
- 2:53
Franck Muller - Making the Dialsby repairwatches6,375 views
- 9:58
Tryally Gear 2-2Bby tryally6,543 views
- 0:37
Center Drilling on a Latheby ManufacturingET24,362 views
Hello, here again a very good video, still very informative, good luck, Thierry cordially
mayhem7090 2 months ago
Thank you Thierry, Soon I will upload new videos.
Good luck to you as well..
From Brazil
Luiz Ally
tryally 2 months ago
what about the chuck. i see that you dont tighten it very much when you attach it to the lathe. so does it tighten itself good enought while the thread is clockwise and the lathe is turning counter clockwise?
tm868686 7 months ago
@tm868686
Hi,
You are totally right, the lathe is turning counter clockwise and does it tighten itself too.
Regards from Brazil
Luiz Ally
tryally 7 months ago
Hello once again.
Nice video.As always delightful.
One question?The mill and lathe are CNC controlled.Have you done by yourself this "upgrade"?Do you have some kind a history how have you done it?
Thx.
princeigorash 9 months ago
@princeigorash Hi,
In my Cnc system, I use the original drive and stepper motor too.
But, for my lathe I make some mechanical modifications with stepper motor nema 17, the results are very good for all work, with any material.
In yahoo Sherline group you can see many pictures about it, and as soon as possible I will make a video and to show it too.
My best wishes from Brazil to you in Romania.
Luiz Ally
tryally 9 months ago