E-revo speed test from 81.9mph to .... ?

We had a blast this weekend doing test runs with my friend's E-revo, we had some trouble in last weeks, and this last friday the Monster mamba max ESC we were using finaly let go, but it was a Version 2....!! We now installed the Version 3 and it was better, power was back and we could work on our setup, We did a lot of runs, some high speed wheelies and crash in long grass not shown in videos...

Special thanks to Gerald from GRCSR of St-Rock de l'Achigan!!
We are also working on improving the 91.2mph !!
Currently the unofficial fastest known E-revo and fastest Monster truck!

Category:

Autos & Vehicles

Tags:

• E-revo
• brushless
• top
• speed
• fastest
• mt
• neu
• mmm
• record
• 91
• mph
• traxxas
• abmods
• mvbashers

[thedutchgtaman]

lol some peaple talks big boy about the're nitro truck....

actually you need to drive this car, see of the're rc car is still fast xD

[MikePeperni]

@thedutchgtaman hehe thx! actually, we have the fastest (im aware of) brushless and nitro traxxas revo,  91.2mph for electric and 75mph for nitro :)

[mefuzion]

hey there nice run... can i ask you something, is it better to tape those tires or put line outside? tape fails after some months, while line fails more often but its replaceable. what did you do for this run? thx!

[MikePeperni]

@mefuzion We dont use tape, i hate that solution, not effective for that kind of speed anyway. We used fishing line, and never had to replace it in the entire summer, the tire was worn at the end of summer , the fishing line was kind of welded on the tire. thx! :)

[mefuzion]

@MikePeperni ca etait trop utile merci beaucoup mon ami!

[MikePeperni]

@mefuzion No problem :)

[tinva2011]

what engine are u using, what did u change to the e-revo to get taht speed

[mikesab221]

Make sure all for pieces of fuel line aster the exact same length though, otherwise it will pull and you could lose some speed, or not track straight.

[mikesab221]

You'll find it works allot better if you disassemble the shocks and user Niro fuel line to lower the suspension. Just remove the rod/piston, and put a piece of fuel line on the rod, reassemble, and oil.

[sklenulo]

where can i buy that mod1 gearing? thanks

[mefuzion]

@MikePeperni k next question... i have failed putting line to them, it either goes out from the side because it balloons on the center or it becomes loose on the knot. do you have any technique-advice for the particular tires? do you also tie them in the middle?

i run them without lining also... they dont balloon much but i am afraid on high speed