Steel Rolling

Rolling 3/16 cold-rolled steel wire at my chop with homemade roller

Category:

Howto & Style

Tags:

• Steel
• Rolling

[30timson]

хоть бы убрался в гараже такой хаос

[pbh153]

what kind of medicine are you taking/ or not taking?

[kc7fys]

Very nice work. I have to comment, however, you appear either agitated, or somehow impaired. I found myself afraid you were going to hurt yourself. Still, a very good demonstration of an effective bender. Thanks for the upload!

[ArtemiaSalina]

This guy looks dangerous to work around.

[Yeaboihah911]

Take it easy grandpa.... Nice shop

[markjacksmarkjacks]

@mbungabungah Thanks for your support regarding my shop. I love to start projects and then they collect and I come to a point where I need to decide which to unload and which to finish. I had a major job come in recently and it forced me to make some of those decisions which were not easy but It is also great to have the elbow room.

[markjacksmarkjacks]

3/8ths? I mostly use 3/16th cold rolled. I did roll 1/4 in. successfully. I have tried 1/2 inch conduit also but it was too much for the pot metal(or whatever they are) pulleys. I thought I would replace them with steel pullys and try it again. The conduit was less yielding stiffness-wise so I had to push harder to get them to go through but I believe if it did it in a series of shallower passes It would work fine.

[porpoisefathom]

could you roll 3/8ths rb with this?

[krpelkey]

fuckin slobs

[Ajax2341]

You look like your mad.