EBN - More fun with the HHO torch!

118 plates, 140vDC, 25-30 amps, 15-20 lpm of HHO

This combo makes for one SCREAMING torch when pushed through a .035 tip. An insane amount of HHO gas being generated here for such a small tip. We really needed about a .090 tip for this much gas but did not have one handy. So we made do with what we had.

Enjoy ... this was a lot more fun in person!!!

Category:

Science & Technology

Tags:

• HHO
• HOH
• Browns
• Gas
• Electrolysis
• Water
• Fuel
• Hydrogen
• diy
• gadget
• Hydroxy
• OxyHydrogen
• EBN
• Energy
• Builders

[tonijesus1]

Impressive video. I am curious about this technologie. Can you tell me if the space between plates is critical and how does that afect HHO production? (kinda more space less production or reverse). Also, are you using some king of fire arrester device? When you say you are using power limit device it means your controlling the power or using a device to cut the power above a level like a circuit breaker? Thank you in davance

[SmartScarecrow]

@tonijesus1 - wider plate spacing requires stronger electrolyte mix - no difference in overall performance - I do use a pulse width modulator to control total watts power to the device but also have circuit breakers - best flash back arrester I have used is the double bubblers -

[swirlingabyss]

Current limiting. Do it.

[SmartScarecrow]

@swirlingabyss - sorry, but I have have no idea what you are talking about - my electrolysis device is designed to use about 2000w delivered as 120vAC at 18 amps ... I use very effective techniques to limit the power into my device so that it does not exceed the design limits of the device ... however, when you are pulling 18a on a 20a circuit and someone in the house decides to use an appliance on the same circuit, you can pop a circuit breaker sometimes ...

[panzuman]

is iy possible to make a 1 lpm torch? im thinking about trying to mak a small compact design

[SmartScarecrow]

@panzuman - yes, but your flame tip is will be a hypo needle or maybe a basket ball filler needle ... very small orifice ... the gas needs to be at a critical velocity to keep the flame front from going right back up the tube and blowing up your gizmo ... so the less gas you make, the tinier the exit hole has to be to keep that velocity up ...

[PigsCanFly99]

"I think the air turbulence is knocking things over" should read: "I think the hydrogen (gas) turbulence is knocking things over." 

[aterack833]

try using a thermal reset breaker and a fan and have it 1 amp lower then your breakers output , then it will trip but reset on its own verry quickly and you wont have to go to the basement

[yangfilo]

Have you experimented with adding compressed air after the metal starts to glow?

[00011theman]

@dmgcat you mean flashback?

[kkkkorman]

that is the cooles one i have ever seen

[MadHatterTruth]

you suck at playing with fire