Audi S6 2,2 Turbo 0-100 5,5 sek

Fullt Orginal Audi S6 med AAN motorn

Category:

Autos & Vehicles

Tags:

• Audi
• S6

[avantus]

stock is 1.9 bar. That is 0.9bar overpressure.

2.1 is certainly tuned ;)

[jimiliborah]

not for s6, when i chipped my car i got 1,5 bar, orginal is 1,1 bar!

[avantus]

full original? ;)

it shows 2.1 bar, that's more than original.

[jimiliborah]

no, its not... 1 bar is atmosferic or what they call it, so it is only 1,1 bar in real life. Dunno why they show 2,1 bar when it only charges 1,1 bar.

[dipspb]

Is there SMS or MTM chip installed? K24 turbo?

[jimiliborah]

There is NO chip in this movie, but i installed a REVO chip a couple of monts ago.. it now charge 1,5 bar and does 0-100 in 4,8 sec

[yomonstruo]

these 2.2 turbo are really fast

[velhonen]

It was 6,0 sec

[BigMuff20V]

This is the pressure in the onboard computer which is always 1 bar higher than the actual boost pressure always count minus 1 bar in the on-board computer

[ringlol]

This is stock, take 2.1 - 1bar for the actuall boost pressure. If it was charging 2.1 it would be moving ALOT quicker :)

[Skrattmannen91]

You can hear on the engine that its not 2.1 bar for sure. No blow of sound or anything like that, and with 2.1 bar this car would have accelerated way faster.

[MrPulangurata]

thanx for your reply buddy :) As I said the turbo doesn't really 'kick in' that much....I felt the diference when I drive tested another S4 (also stock) I could really feel the turbo kick....but unfortunately that one had serious ABS problems or something serious, when u press the brake pedal the engine would stall at any speed....which can be dangerous at high speeds!!!

[lookovertheabyss]

@MrPulangurata

Then it is tuned ;-)

Its normally by this pressure.

Stock 0,7bar@1950rpm, our's did 1,2bar@2900rpm and 1,5bar should came aroun d 3,5 -4k upm.

Its because the turbo needs more time to get this pressure, but at 4k he's kicking asses, didn't it?

[MrPulangurata]

h :) i I recently bought an audi S4 '93 and it feels like the turbo is really bad..(it shows on the board computer 1.5 max) and the turbo doesn't really kick in as it should at around 4000rpm. Could u give me some advise what to check, maybe there's a 'leak' somewhere and it's loosing pressure???? Thanx :)

[chronikuss]

it is over 6 seconds for 20-100km/h

[paultatters]

What a noise!

[lookovertheabyss]

@joaoteixeira1

1,8bar means 1 bar air+0,8 bar turbo and yes, it is the stock pressure.

Deppending on the air temperatur and other things, 0,6-0,8bar is normal ;-)

The K24-7000's max boost is 1,5bar(2,5bar with air pressure), but it can't do more then 150tkm in this state(303-315hp MTM).

If your car isn't fast as this, then something couldn't be correct, or it's your own feeling and your's is faster ;-)

[joaoteixeira1]

@lookovertheabyss I have a audi 100 S4 has the same engine (AAN 2.2 TURBO 20 V) and the series comes with 1.8 bar pressure.

From the moment I have 2.2 bar pressure, is the maximum that can withstand turbo K24 -7000. This car in question has more pressure than normal, and dare say that is chipped, because my have more turbo and even more direct admission, and is not so fast