How To Install Replace Door Panel Chevy GMC Silverado Sierra Tahoe Yukon 99-02 1AAuto.com

http://www.1aauto.com/1A/-/GMC/Yukon
1A Auto shows you how to remove or replace the interior door panel trim on your vehicle. You need to remove the door panel for a number of different repairs, for example door handles, window regulators, power window motors, door locks and more. This video, will help you do this.

Category:

Autos & Vehicles

Tags:

• how
• to
• howto
• fix
• repair
• replace
• install
• change
• put
• in
• take
• out
• remove
• attach
• door
• panel
• trim
• plastic
• fabric
• chevy
• gmc
• silverado
• sierra
• tahoe
• yukon
• 1999
• 2000
• 2001
• 2002
• 99
• 00
• 01
• 02
• installation
• instruction
• tutorial
• video

[Pachyderm12]

My speaker or woofer has come loose and hanging inside the "mesh" speaker cover. Can I pry the mesh off the door panel to access the speakers without removing the whole door panel? Thanks!!

[1aauto]

@Pachyderm12 You would need to take the door panel off so that you can screw it back into the door.

[Cousinorange]

how you remove the back speaker panel in the trunk on a 2001 chevy tahoe ls

[1aauto]

@Cousinorange Currently we do not have a repair video that shows this procedure. It may be held in with a couple of screws and/or push pins to hold it in place. Hope this helps.

[MrTerry2nd]

How do you replace the bulb on the door panel light? I own a '99 silverado and the bulb is burned out. Thanks

[1aauto]

@MrTerry2nd If there isn't a screw on the front of the lens that holds it into place, you would need to remove the door panel as shown in the video. Then you should be able to access it from the back of the door panel.

[bowhunter2439]

@sdrew2 Your right I just snaped the front screw tab , also the second screw holding the door in is located behind the door lock assembley, great vid though...!!

[sdgardner1954]

Great Video, I had to replace the speaker in my 2000 Sierra. Easiest Iever took a door panel off.

[sdrew2]

Thanks for the Video. Just a word of caution. I broke off a plastic part in trying to use these instructons on a 2003 Yukon. While the panel looks identical to the one here, the power window swith asssembly is attached at the front end from underneath (pointy end) with a small screw that is accessed from below but only after the door panel is pulled away from the door. If you try to pry it out as shown, it'll snap!

[MrPittsburghJ]

should be the same on my 06 sierra crew cab right? Good video. I'm always afraid of tugging on things I think will snap off... but are screwed on by some hidden screw!