stroked kenne bell 2v mustang GT "pre-tune" 430RWHP @ 6 psi

FINALLY! here she is folks! 4.6 2v stroked to 302, forged kelloge stroker crank, manley rods, JE custom dished pistions, TRICKFLOW 2v HEADS with stage 3 port work done, more agressive blower cams, 60 lbs injectors, ugraded fuel system, and intercooled kenne bell 2.1 kit with a "9 lb" pulley, putting only 430RWHP on 6 lbs of BOOST! check in about a week, ordered 8 rib conversion, and pushing the blower to MAX BOOST which matt at kenne bell stated "18 psi"

Category:

Autos & Vehicles

Tags:

• TRICKFLOW
• 2v
• HEADS
• Cammed
• cams
• mustang
• GT
• kenne
• bell
• blown
• stroked

[Willy51991]

This yours Presto? It's badass!!!!

[prestonludwig]

@Willy51991

yessir! willie is that neil?????????

[NitroGadvRules]

These trickflow heads are so good, I was thinkning about going 4v but these even though they don't flow as well as ported 4v still manage to make better numbers than the 4v and the low end torque is much better as well. Theres definitely more to it than flow when it comes to heads and trickflow definitely knows how to power.

[prestonludwig]

@NitroGadvRules

well in actuality, 4v's are always going to out perform 2vs, but that doesn't mean we're going to not die trying~! i think in April i will be pulling off the KB 2.1 and going turbo. right now i'm maxing out that blower, and its just too small for all the port work, aggressive cams, stroked built motor. NEED MORE BOOST!

[3000gtvr45Lebtt]

@prestonludwig man, just slap a 5.0 whipple on there and bricks will be shat

[hotwheelz28]

holly shit dude. Shes a beast. Just wait till she sees over 12psi